What is the price difference between strip steel and hot rolled coil

 What is the price difference between strip steel and hot rolled coil

　　The price difference between strip and hot rolled coil is affected by two factors:

　　Cost factor: Due to the large investment gap in production equipment and facilities, there is a certain gap in production costs. There are also certain differences in the technical requirements of finished products, which will also have a certain impact on production costs. This effect is the most basic factor, and the usual price difference mainly depends on it, generally around 150 yuan/ton.

　　Market supply and demand factors: Market supply and demand factors sometimes distort the impact of cost on prices. In the past few years, there have been cases where the prices of the two have been inverted (the price of strip steel exceeds that of coils).



评论

发表评论

此博客中的热门博文

Introduction to 20 # carbon steel plate

图片
Introduction to 20 # carbon steel plate       20 # belongs to superior carbon steel, which complies with GB/T711 standard. 20% of 20 # steel refers to carbon content, which is 0.2%, belonging to low carbon steel. Steel can be divided into low carbon steel, medium carbon steel and high carbon steel. Mild steel - carbon content is generally less than 0.25%; Medium carbon steel - carbon content is generally between 0.25 and 0.60%; High carbon steel - carbon content is generally greater than 0.60%. 　　Domestic and international correspondence of 20 # steel plate: refer to the corresponding steel grade: China's GB/JB standard steel grade is 20, China's Taiwan CNS standard steel grade S20C, Germany's DIN standard material number 1.0402, Germany's DIN standard steel grade CK22/C22. British BS standard steel grade IC22, French AFNOR standard steel grade CC20, French NF standard steel grade C22, Italian UNI standard steel grade C20/C21, Belgian NBN standard steel grade C25-1, Swe...
阅读全文

Rust removal of steel

图片
 Rust removal of steel When steel corrodes, as the volume increases, the steel bars in reinforced concrete will cause the concrete to swell and crack. At present, there are three general rust removal methods as follows. 1) Wire brush to remove rust All the rust on the surface of the steel can be brushed off manually with a steel wire or a semi-automatic wire brush until the metal surface is exposed. This method has low work efficiency and the quality of rust removal cannot be guaranteed. 2) Pickling and derusting Put the rusted steel into the pickling tank, remove the oil and rust respectively until the surface of the component is all iron gray, and clean it up to ensure that there is no residual acid on the surface. This method is more thorough than manual rust removal, with high work efficiency and good effect. 3) Sand blasting to remove rust Clean the rust on the surface of the steel through a sandblasting machine until the surface of the component is off-white, and there must b...
阅读全文

Introduction to angle steel

   Introduction to angle steel        The angle steel can be used to form various stressed members according to the different needs of the structure, and can also be used as a connector between members. It is widely used in various building structures and engineering structures, such as house beams, bridges, transmission towers, hoisting and transportation machinery, ships, industrial furnaces, reaction towers, container racks, cable trench supports, power piping, bus support installation, warehouse shelves, etc. 　　The angle steel is a carbon structural steel used for construction. It is a simple section steel, mainly used for metal components and plant frames. Good weldability, plastic deformation performance and certain mechanical strength are required in use. The raw steel billet for angle steel production is low carbon square steel billet, and the finished angle steel is delivered in the hot rolling forming, normalizing or hot rolling state.
阅读全文